1. Click Settings à Remotes
2. Click Manage
3. Click New
4. Type in Remote Name
5. Click Edit Commands
6. Click “No commands defined. Select here to add a command”
7. Type in Command Name
8. Click Learned
9. Get remote control ready
10. Click Record and follow steps pointing remote at IR sensor on bottom of device as shown in picture
11. Push remote control button at sensor and hold until green bar turns blue. Release when bar turns blue and repeat until…
12. Click OK
13. Click Back
14. Click Done
15. Click Dashboard in Toolbar at left
16. Click Remotes and then choose pre made page to start from
17. Select Modify button in top right corner (location may vary depending on pageset)
18. Select button you wish to add signal to
19. Click Actions box
20. Here we add the signal we just recorded
21. Click remoteCommand in yellow and chose from your list of remotes/signals
22. Select the remote then the signal then click select. You should end up with this.
23. Repeat process for all remote signals and buttons needed.
Please take a brief survey to help us improve.